Sharp FO-1470 Service Manual page 8

UX-510UA
FO-1470U
3. Assembly and connections
1
Plug the power cord into a 120V, 60Hz, grounded(3-prong) outlet.
• Caution: Do not plug the power cord into any other kind of outlet.
This will damage the machine and is not covered under the
warranty.
• The machine does not have a power on/off switch, so the power
is turned on and off by simply plugging in or unplugging the power
cord.
Note: If your area experiences a high incidence of lightning or power
surges, we recommend that you install surge protectors for
the power and telephone lines. Surge protectors can be
purchased at most telephone specialty stores.
2
Connect the handset as shown and place it on the handset rest.
3
Insert one end of the line cord into the jack on the back of the ma-
chine marked TEL.LINE. Insert the other end into a standard (RJ11C)
single-line wall telephone jack.
Be sure to insert the line into the TEL.LINE jack.
Do not insert into the TEL.SET jack.
Note: The fax machine is set for tone dialing. If you are on a pulse
dial line, you must set the fax machine for pulse dialing.
Press the keys on the operation panel as follows:
1. Press these keys:
The display will show:
DIAL MODE
2. Press 1 to select tone dialing, or 2
to select pulse dialing.
3. Press the STOP key to return to the date
and time display.
Make sure the handset cord
goes into the unmarked jack
on the side of the machine!
Use the handset to make ordinary
phone calls, or to transmit and receive
faxes manually.
FUNCTION
4
TONE PULSE
1
2
or
STOP
4
Insert the paper tray into the back of the fax as shown.
4. Loading printing paper
The paper tray holds the paper on which received documents and
copies are printed. Up to 200 sheets of letter or legal paper from
16 to 20 lbs. (60 to 75 g/m
be loaded when using heavier paper. The maximum allowed paper
2
weight is 24 lbs. (90 g/m ).
Note: When receiving or copying documents, do not allow more than
100 pages to collect in the received documents outlet. Otherwise,
the outlet may become obstructed, causing paper jams.
• Caution! Do not use the blank side of paper that has already been
printed on.
1
Remove the paper cover if it is on the paper tray.
• If you are going to load legal size paper, flip up the paper tray
extender.
2
Fan the paper, and then tap the edge against a flat surface to even
the stack.
1 – 6
2
) can be loaded in the tray. Less sheets can