Component Installation Overview - HP 245161-B22 - 10642 42U Rack Shock Pallet Reference Manual

Observe the general guidelines when installing your components:
•
Refer to the user documentation that was shipped with the component for
detailed instructions on installing a specific component or third-party hardware.
•
Refer to Appendix A, "Electrostatic Discharge," before installing components
into the rack.
•
Use the configuration prepared with the Rack Builder Online software as a
guideline for installing the components.
•
Install the heavier components first from the bottom of the rack up.
•
Be sure to balance the weight load between bayed racks. For example, if you
have several UPS units and several servers, do not install all of the UPS units into
one rack. Instead distribute them evenly in the bottom positions of each rack.
•
Allow a minimum clearance of 76 cm (30 inches) between the wall and the rear
of the rack to provide adequate access for installation and service.

Component Installation Overview

NOTE: The stabilizer feet should be installed before any component installation.
IMPORTANT: The following installation instructions are for standard installations. For specific
installation instructions, refer to the documentation included with your component.
The following steps outline the sequence for installing rack-mountable components
in a rack. You should install zero U devices first, such as PDUs, switch boxes, and
so on.
1. Use the template to measure and mark the rack for correct placement of the
installation hardware.
2. Install the cage nuts into the rack.
3. Prepare and install the adjustable fixed rails, sliding rails, or both.
4. Prepare the component for mounting it into the rack.
5. Install the component into the rack and secure it.
6. Attach the cable management arm to the rack and then to the component.
HP 10842 Rack Reference Guide
Installing Components in the Rack
4-3