HP 245161-B22 - 10642 42U Rack Shock Pallet Reference Manual page 45

4. Note the orientation of the sliding rail assembly:
a. The front of the sliding rail assembly (1) allows the inner slide to move
forward on ball bearings.
b. The back of the sliding rail assembly (2) has a stop for the inner slide.
NOTE: While matching fronts, lay one rack-mounting bracket and one sliding rail
assembly together so that the screw holes are aligned.
1
Figure 4-8: Orienting the sliding rail assembly
5. Extend the inner slide in the sliding rail assembly until the screw holes in the
rack-mounting bracket and the sliding rail assembly are aligned (1). (Refer to
Figure 4-9.) Secure the sliding rail assembly to the rack-mounting bracket by
inserting one 8-32 x 3/8 screw into each of the three exposed holes, two near the
rear and one near the front of the sliding rail assembly.
6. Adjust the inner slide until you can access another screw hole (2) and insert one
8-32 x 3/8 screw. (Refer to Figure 4-9.)
HP 10842 Rack Reference Guide
Installing Components in the Rack
2
4-11