3.2.10.10 Base Frame Assembly Removal
1.
Remove the printer mechanism unit. (Refer to Section 3.2.6.)
2.
Remove the paper eject frame. (Refer to Section 3.2.10.7.)
3.
Remove the CR unit. (Refer to Section 3.2.10.9.)
4.
Remove 1 E-ring fixing the gear (46) and compression spring (1.96) to the left frame assembly. Then
remove the gear along with 2 plain washers and the compression spring.
; Be careful not to lose the compression spring. It might spring out when you remove the E-ring.
5.
Remove the tractor release cam.
6.
Adjusting the sub tractor release cam with the cutout in the left frame assembly, and remove it from
the tractor release shaft. (Refer to the figure below.)
7.
Remove 5 screws (CBS, 3X6) securing the base frame assembly to the printer mechanism unit, then
lift up the base frame assembly and remove it.
Rev. A
WORK POINT
Figure 3-24. Base Frame Assembly Removal
Disassembly and Assembly
3-27