Paper Load Roller Unit Removal - Epson Stylus COLOR 1520 Service Manual

EPSON Stylus &2/25 1520

3.2.10.11 Paper Load Roller Unit Removal

1. Remove the printer mechanism unit. (Refer to Section 3.2.6.)
2. Remove the paper eject frame. (Refer to Section 3.2.10.7.)
3. Remove the CR unit. (Refer to Section 3.2.10.9.)
4. Remove the base frame assembly. (Refer to Section 3.2.10.10.)
5. Attach the knob to the PF roller shaft, and press the trigger lever down. Then rotate the paper load
roller unit by turning the knob clock wise to hold the edge guide unit down.
6. Remove 1 screw (CBP, 3X8) securing the paper eject drive unit to the left frame assembly, and
remove the paper eject drive unit by lifting up the front edge.
7. Release the joints for the right and left slide covers and the edge guide.
8. Remove the E-ring located at left end of the paper load roller .
9. Adjust the paper load roller bushing with the cutout on the right frame.
10. Disengage the paper load gear at the right end of the paper load roller unit from the ASF transmission
gears in the middle frame. Then remove the paper load roller unit by sliding it toward the left frame
assembly.
3-28
Figure 3-25. Paper Eject Drive Unit Removal
Rev. A