Television Safety - Hitachi 42PD3000 User Manual

This plasma television has been designed and manufactured to meet international safety
standards, but like any electrical equipment, care must be taken if you are to obtain the best
results and safety is to be assured.
DO read the operating instructions before you
attempt to use the equipment.
DO place your TV on a flat surface, or if
DO ensure that all connections, (including the
mains plug, extension leads and inter-
connections between the pieces of equipment),
are properly made and in accordance with the
manufacturers instructions. Switch off and
withdraw the mains plug before making or
IF you intend placing this TV into a cabinet or a wall
alcove, please ensure there is at least a 100mm
(10cm) gap to the sides, rear and top of the TV. This
is to allow for adequate ventilation during your TV's
DO NOT remove any fixed cover as this may
expose dangerous voltages.
DO NOT continue to operate the equipment if
you are in any doubt about it working normally
or if it is damaged in any way - switch off,
withdraw the mains plug and consult your dealer.
4
supplied, the stand accessory.
changing connections.
AUDIO VISUAL CONTROL STATION AV3000F
operation.
AUDIO VISUAL CONTROL STATION AV3000F
DO consult your dealer if you are in any doubt
about installation, operation or safety of your
equipment.
DO be careful with any glass panels or doors on
equipment.
DO observe the manufacturers instructions when
connecting extension leads to your TV. The fuse
should be a 5 Amp fuse with the safety symbols
and displayed. If you are in any doubt
about the extension installation, please consult a
competent electrician.
SHOULD you require to replace the fuse in the
moulded plug with a new fuse, then please replace
with one of the same value, type and approval as the
original. Ensure the fuse cover is returned to its
original position.
TO prevent scratching or damaging the plasma
screen face, do not knock or rub the surface with
sharp or hard objects. Clean the screen with a soft
cloth moistened with warm water and dry with a soft
cloth. A mild soap may be used if the screen is
extremely dirty. Do not use harsh or abrasive cleaners!
DO NOT position the plasma screen on top of the
AVC unit as it could cause damage to the unit.
DO NOT listen to headphones at high volume,
as such use can permanently damage your
hearing.
AUDIO VISUAL CONTROL STATION AV3000F