Programming Error Codes - Hitachi SJ300 Series Quick Reference Manual

Analog Output Function Listing
The following table shows all eight functions available for assignment to
the three analog output terminals:
• Terminal [FM], option set by C027
• Terminal [AM], option set by C028
• Terminal [AMI], option set by C029
Option Function
Code Name
00 Output
frequency
01 Output current Motor current (% of
02 Output torque
03 Digital output
frequency
04 Output voltage Rated output voltage to
05 Input power
06 Electronic
thermal
overload
07 LAD
frequency

Programming Error Codes

The SJ300 inverter operator keypad displays a special code (begins with
the character) to indicate a programming error. Programming errors
exist when one parameter conflicts with the meaningful range permitted
by related parameter(s). Note that particular real-time frequency (speed)
input levels can cause a conflict in some situations. After a conflict exists,
the error code will appear on the display, or you can view it later with
D090 in Monitor Mode. Also, the PGM LED on the display will flash
ON/OFF when programming. These indications are automatically cleared
when the parameter is corrected to the allowed range.
Description
Actual motor speed,
represented by PWM
signal
maximum rated output
current), represented by
PWM signal
Rated output torque
Output frequency (avail-
able only at [FM] output)
motor
Rated input power
Percentage of electronic
overload attained
Internal ramp generator
frequency
38
Corresponding
Signal Range
0 to max. frequency in Hz
0 to 200%
0 to 200%
0 to max. frequency in Hz
0 to 100%
0 to 200%
0 to 100%
0 to max. frequency in Hz