Table of Contents
Advertisement
-
Execute the following command to set Half Duplex communication, 10Mbps.
ok transfer-speed=10
ok half-duplex
-
Execute the following command to display the current settings.
ok .properties
The following example shows the current settings of a SE0X7GD1X card installed in a SPARC Enterprise M9000.
{6} ok cd /pci@4,600000/pci@0/FJSV,e2ta@4
{6} ok .properties
duplex
transfer-speed
status
assigned-addresses
local-mac-address
fjgiga-rev
product-name
device_type
address-bits
max-frame-size
reg
model
compatible
name
media-type
version
fcode-rom-offset
66mhz-capable
fast-back-to-back
devsel-speed
latency-timer
max-latency
min-grant
interrupts
cache-line-size
class-code
subsystem-id
subsystem-vendor-id
revision-id
device-id
vendor-id
*1: Displayed only when half-duplex is set.
*2: Displayed only when transfer-speed is set to a specific value. [10Mbps: 0xa, 100Mbps: 0x64, 1000Mbps: 0x3e8]
Note: *1 and *2 are not displayed in the default configuration.
Note
-
Changes to FCode settings are lost after executing the reset-all command from the ok prompt (See "How to Return to Default
FCode Settings (Auto-Negotiation Mode)"), or after power cycling the system.
half
<-- (*1)
0000000a
<-- (*2)
okay
82032010 00000000 00100000 00000000 00010000
82032018 00000000 00110000 00000000 00010000
82032030 00000000 00120000 00000000 00010000
00 e0 ed 12 a8 3c
000000c3
FJSV,e2ta
network
00000030
00004000
00032000 00000000 00000000 00000000 00000000
03032010 00000000 00000000 00000000 00010000
03032018 00000000 00000000 00000000 00010000
02032030 00000000 00000000 00000000 00010000
Broadcom,BCM5715C
fjgi
FJSV,e2ta
1000BASE-T
1.0
00000000
00000001
00000040
00000000
00000040
00000001
00000010
00020000
00000066
00001374
000000a3
00001678
000014e4
- 36 -
Advertisement
Table of Contents
