Part Names And Features Of Hardware - Fujitsu PCI Gigabit Ethernet User Manual

Item
Power Requirements
Connections
Note
-
SE0X7GD2X only support full duplex connection. Half-duplex connection is not supported.
-
When using 1000Mbps transmission rate with SE0X7GD1X, SE0X7GQ1X and SE0X7GQ2X, "Auto-Negotiation" must be set to
"on".

1.2.2 Part Names and Features of Hardware

Figure 1.1 to 1.4 shows the appearance of the Gigabit Ethernet cards. The part names and features are listed as follows.
- Connection
The SE0X7GD2X allows optical fibre cable connection; the SE0X7GD1X, SE0X7GQ1X and SE0X7GQ2X allow twisted pair cable
connection. See the section
- LEDs
The LEDs of the Gigabit Ethernet cards are listed in
detailed information.
Table 1.3 LEDs
Gigabit Ethernet cards
SE0X7GD2X(1000BASE-SX)
SE0X7GD1X(10/100/1000BASE-T)
SE0X7GQ1X
SE0X7GQ2X (10/100/1000BASE-T)
Maximum: 9.1W (SE0X7GD1X), 9.2W (SE0X7GD2X),
15.0W (SE0X7GQ1X), 12.8W (SE0X7GQ2X)
1000Base-SX (SE0X7GD2X): Multi-mode Fibre LC-SC: 62.5/125 micron and 50/125
micron (Card side is LC. Used when connecting to a device with an SC connector.), LC-
LC: 62.5/125 micron and 50/125 micron
10/100/1000Base-T (SE0X7GD1X, SE0X7GQ1X, SE0X7GQ2X): CAT5e Cable
(CAT5 cable can also be used for 10/100Mbps.)
"Chapter 2 Gigabit Ethernet Card
"Table 1.3
Hardware Specification
Installation" for detailed information.
LEDs". See "Appendix B Gigabit Ethernet Card LED
Two LEDs per port: LINK LED, ACT LED
Three LEDs per port: 1000M LED, 100M LED, LINK/ACT
LED
Two LEDs per port: LINK LED, ACT LED
- 3 -
Diagnosis" for
LEDs