Epson PowerLite 1705c User Manual page 66

note
If you don't need the other
network ports, disable
them by deselecting their
checkboxes. If more than
one network port is
enabled, the projector
software warns you to turn
off AirPort when you first
connect the projector.
Disregard this message.
Your AirPort network and
base station names may be
different. To check or
change your AirPort
network name, start the
AirPort Admin utility,
select your base station,
and click .
Configure
Click
Show All
, then make any
Settings
changes you want on the
AirPort tab.
If you're connecting to
your projector in static IP
mode, deselect the
Distribute IP addresses
checkbox. Make sure your
projector's gateway address
is identical to the base
station's IP address, and
the first three segments of
the projector's IP address
are identical to the first
three segments of the base
station's IP address.
Presenting Through a Wireless Network
66
3. Make sure Location is set to
Select
Automatic
Select Network Port
Configurations
Then select AirPort
4. Select
Network Port Configurations
menu.
5. Under Port Configurations, select
6. Click
Apply Now
7. Start the AirPort Admin utility. Select your base station, then
click .
Configure
8. On the AirPort tab, make sure your AirPort network name
matches your projector's ESSID. If not, enter the projector's
ESSID in the AirPort Network text box and click
9. If you turned DHCP on in your projector's advanced menu, click
the Network tab and make sure the
checkbox is selected. If you need to select it, click
.
Automatic
in the Show pull-down
AirPort
. Then close the window.
Distribute IP addresses
.
.
Update
.
Update