Epson BrightLink 450Wi User Manual page 102

note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
in
Communication ON
the Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).
Using the Projector on a Network
102
5. Enter the IP address for the SMTP server for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
To enter numbers, use the arrow buttons on the remote control to
select each number on the screen, then press the
When you're finished entering an address in the network menu,
highlight , then press the
Finish
6. Enter the SMTP server's port number. The default value is 25.
You can enter a numeric value from 1 to 65535.
7. Choose one of the
the e-mail address and the contents of the message that you will
receive when a problem or warning occurs. You can register up to
three addresses. You can enter up to 32 alphanumeric characters
for the e-mail address.
8. When you're done making these settings, press
and press
Complete
save your settings.
When the selected problem or warning occurs, an e-mail message is
sent to the specified notification addresses. The subject line of the
e-mail is
EPSON Projector
The e-mail includes the following information:
■ Line 1: The name of the projector where the problem has
occurred
■ Line 2: The IP address of the projector where the problem has
occurred
■ Line 3: Details of the problem
button.
Enter
fields and press
Address
, then choose
Enter Yes
.
button.
Enter
. Then enter
Enter
. Choose
Esc
and press to
Enter