Epson EMP EMP-1825 User Manual page 78

Problem Solving
Check
Is direct sunlight or strong light from fluorescent lamps
shining onto the remote receiver?
Is the correct setting for the remote receiver selected?
Are the remote control ID and the projector ID matched?
Are the batteries dead or have the batteries been inserted
correctly?
Was a remote control button pressed for more than 30
seconds?
f Mail is not received even if an abnormality occurs in the projector (EMP-1825 only)
Check
Is "Standby Mode" set to "Network On"?
Did a fatal abnormality occur and the projector come to a
sudden stop?
Is power being supplied to the projector?
Is the LAN cable connected correctly?
Is "Mail" set correctly in the configuration menu?
Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the
remote receiver to "Off" from "Remote Receiver" in the configuration menu. s"Settings"-"Remote
receiver" p.45
Check the "Remote Receiver" from the configuration menu. s"Settings"-"Remote receiver"
Press the [ID] button on the remote control pointing at the remote receiver of the projector to be operated.
When the remote control operation is disabled, turn off the projector and then turn it on again.s
Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. s
If any of the buttons on the remote control are pressed down for more than 30 seconds, the remote control
stops sending signals (remote control's sleep mode). This feature is to prevent the batteries running down if
the remote control buttons are held down accidentally such as when it is stored in a bag or if an object is
placed on top of it. When the button is released, normal remote control operation resumes.
To use the mail notification function when the projector is in standby, set "Network On" in "Standby Mode"
from the configuration menu. s"Extended"-"Standby Mode"
When the projector comes to a sudden stop, mail cannot be sent.
If the abnormal state continues, contact your local dealer or the nearest address provided in the Support and
Service Guide. s Epson Projector Contact List
Check that your electrical outlet or power source is functioning correctly.
Check that the LAN cable is connected correctly. Reconnect it if it is not connected or it is not connected
correctly. s p.95
Mail notification of abnormalities is sent according to the "Mail" settings in the configuration menu.
Check if it is set correctly. s"Network"-"Mail"
Remedy
Remedy
p.47
p.62
78
p.45
p.32
p.82