Craftsman 17125455 Operating Instructions Manual page 21

ASSEMBLY OF THE GUIDE BUSHING TO THE
ROUTER
1 Place the router upside down on a flat surface For cer-
tain touters it may be necessary to support the router for it
to remain in this position
2 Place the proper guide bushing required for the type of
dovetail to be cut under the router adapter plate as shown
in Figure 33
3 MAKE SURE THAT THE ORIENTATION OF THE
GUIDE BUSHING IS AS SHOWN
4 Position the guide bushing so that the three threaded
holes in the guide bushing line-up with the countersunk
holes in the adapter plate
5 Thread a #10-32 x 3/8" long flathead machine screw
into each of the holes
6 SECURELY TIGHTEN THE SCREWS Refer to Figure
34
FIGURE 33
#10-32 X 3/8" LONG_
FLATHEAD MACHINE SCREW
_/ / #10-32 X 3/8" LONG
\ _J FLATHEAD MACHINE SCREW
ADAPTER PLATE
/ ROUTER
s/
/
GUt0
BUSH1NG
ASSEMBLY
(1/2" DIAMETER
SHOWN)
NOTE THE
ORIENTATION
OFTHE GUIDE
BUSHING
FIGURE 34
GUIDE BUSHING ASSEMBLY
(1/2" DIAMETER SHOWN) "_
NOTE THE ORIENTATION
OFTHE GUIDE BUSHING
ROUTER
2t