Craftsman 17125455 Operating Instructions Manual page 33

18 Remove the workpieces from the Dovetail ,Jig and
check how the workpieces fit together Some adjustments
may be required
Refer to the section TROUBLESHOOTING on page 37
19 FOR CORNER #3, position the drawer back on the top
of the base so that it lines up with the front of the base and
the top edge surface abuts the left top stop block THE
INSIDE OF THE DRAWER BACK FACES UP The words
"INSIDE SURFACE" marked in (d) in the Section, GENER-
AL PREPARATIONS, should be visible See Figure 52
20 Lightly clamp the drawer back in place
21 Position the drawer LEFT side against the front of the
base so that the top surface abuts the left front stop block
THE INSIDE OF THE DRAWER SIDE FACES UP The
words "INSIDE SURFACE" marked in (d) in the Section,
GENERAL PREPARATIONS, should be visible
22 Line up the workpieces so that the end of the drawer
side lines up with the drawer back as shown in Figure 52
23 Continue as in Steps 5 through 16 above
24 After the cut has been made, the workpieces should
took like those illustraied in Figure 53
25 Remove the workpieces from the Dovetail Jig and
check how the workpieces fit together Some adjustments
may be required
Refer to the section TROUBLESHOOTING on page 37
FIGURE 52
I _,'_INSIDE SURFACE" SHOULD BE VISIBLE
ON THIS SURFACE
/TOP OF THE BASE / AUXILIARY TEMPLATE SUPPORT
// _ (AS NEEDED)
// ..... .... •
DF_A"A ER LEFT SiDE / __"" "INSIDE SURFACE" SHOULD BE VISIBLE
ON THIS SURFACE
FIGURE 53
DRAWER BACK \
DOVETAIL
DRAWER LEFT SIDE
33