Craftsman 17125455 Operating Instructions Manual page 31

g Adjust thedepth o fcutto3/8" using t he depth g auge o n
the base oftheDovetail Jig, a sdescribed ina previous
section
This setting i sapproximate and some a djustment may be
required
h Position both ofthetop stop blocks s othatthe "A" faces
the"middle ofthebase" asshown i nFigure 4 8 '
i Position thecam handle sothat t hepointer points t othe
center graduation asshown i nFigure 4 8
FIGURE 48 LEFT TOP STOP BLOCK 'A"FACES TOWARD MIDDLE
OF BASE
. "A" FACES TOWARD MIDDLE
_ OF B___ASE _ / RIGHT TOP STOP BLOCK
/- ....... 7 _------------_-\\V,_ 1A_ /
//_/ POINTER POINTS
'
It
_./ TO CENTER
___ !'[i" V _',", " '_ii]ii_, , /_ _ RIGHT FRONT STOP BLOCK
"\ LEFT FRONT STOP BLOCK \ _"'_
THE FOLLOWING DESCRIBES THE PROCEDURE TO
BE FOLLOWED FOR CUTTING CORNERS 1 AND 3
1 FOR CORNER #1, position the drawer front on the top
of the base so that it lines up with the front of the base and
the top surface abuts the left top stop block THE INSIDE
OF THE DRAWER FRONT FACES AWAY FROM THE
TOP OF THE BASE The words "INSIDE SURFACE"
marked in (d) in the Section, GENERAL PREPARATIONS,
should be visible
2 Ughtly clamp the drawer front in place
3 Position the drawer RIGHT side against the front of the
base so that the top surface abuts the left front stop block
THE INSIDE OF THE DRAWER S_DE FACES AWAY
FROM THE FRONT OF THE BASE
The words "INSIDE SURFACE" marked in (d) in the
Section, GENERAL PREPARATIONS, should be visible.
4 Line up the workpieces so that the end of the drawer
side lines up with the drawer front as shown in Figure 49
5 Securely clamp the drawer side to the base
6 Securely clamp the drawer front to the base
7 Make sure that the parts remain lined up
FIGURE 49
DRAWER FRONT
THE END OF THE DRAWER
SIDE MUST BE LEVEL AND \-._%
FLUSH WITH THE INSIDE
"_,.
SURFACE OF THE DRAW_
%.,
ER FRONT (OR BACK)
'tNSfDE SURFACE" SHOULD BE
VISIBLE ON THIS SURFACE
AUXILIARY TEMPLATE
TOP OFTHE BASE/' SUPPORT (AS NEEDED)
\
" FRONT OF THE BASE
DRAWER RIGHT SIDE
"INSIDE SURFACE" SHOULD BE
NOTE: WORKPIECES WILL BE POSITIONED ON THE JIG AS VISIBLE ONTHIS SURFACE
31