Dell PowerEdge UPS 500T Installation And Configuration Manual page 89

To add devices:
1 Click Search Device from the SNMP menu.
2 Select the Internet Protocol Version supported by SNMP from the Protocol Type list (see Figure 96).
NOTE:
The Protocol Type list displays only if both IPv4 and IPv6 are enabled.
NOTE:
For IPv4, both single device and segment devices searches are supported.
3 IPv4 only. Enter an IPv4 address in the Start IP field and the End IP field (see Figure 96).
Figure 96. Search Device Window (IPv4)
4 IPv6 only. Enter the device's IP address (see Figure 97).
NOTE:
If the IPv6 address is a broadcast IP, all Network Management Cards that support IPv6 within the LAN
are found. The default IPv6 address is broadcast IP ff02::1.
Configuring the Software
89