Hitachi XP P9500 User Manual page 160

3. Creating an HDLM Environment
configuration, memory might become insufficient due to the HAL daemon
this case, the host will not respond.
To avoid this, stop the HAL daemon when executing the
following procedure shows how to stop the HAL daemon.
#
The HAL daemon detects hardware configurations changes, for example,
when a USB device or CD-ROM is inserted.
To stop the HAL daemon:
1. Check the status of the HAL daemon.
Execute the
the daemon is running,
# /sbin/service haldaemon status
If the daemon is not running,
2. Check the result of step 1. If the HAL daemon is running, stop the daemon.
Execute the
it might take a while to stop the daemon completely.
# /sbin/service haldaemon stop
3. Make sure that the HAL daemon is stopped.
Execute the
is not running.
# /sbin/service haldaemon status
4. Execute the dlmcfgmgr utility (
configure the HDLM device.
# /sbin/dlmcfgmgr -r
or
136
command to check the HAL daemon status. If
/sbin/service
will appear.
running
stopped
command to stop the HAL daemon. Note that
/sbin/service
command to make sure that the HAL daemon
/sbin/service
dlmcfgmgr -r or dlmcfgmgr -i
dlmcfgmgr
will appear.
#
. In
utility. The
) to