Hitachi XP P9500 User Manual page 205

:
:
title XEN
root (hd0,1)
kernel /boot/xen.gz
module /boot/vmlinuz-2.6.16.60-0.21-xen root=/dev/disk/
by-id/scsi-1HITACHI_D60H03750027-part2 vga=0x31a
dev/sda1 splash=silent showopts
module /boot/initrd-2.6.16.60-0.21-xen
If or the device name (
LABEL
proceed to step 17 and install a new instance of HDLM.
If the device name (
device name (
udev
5. Execute the
mount
Check the correspondence between the SCSI device and
in steps 3 and 4. You will need this information to remove the
# mount
/dev/sda2 on / type ext2 (rw)
/dev/sda1 on /boot type ext2 (rw)
/dev/sda4 on /tmp type ext2 (rw)
/dev/sda5 on /var type ext2 (rw)
/dev/sda6 on /usr type ext2 (rw)
none on /dev/shm type tmpfs (rw)
Check the underlined section.
6. If Red Hat Enterprise Linux, SUSE LINUX Enterprise Server 10, or SUSE
LINUX Enterprise Server 11 is being used, check the SCSI device name in the
file.
proc/swaps
The SCSI device name is displayed in the
7. If the block device name or the
the following commands to check the SCSI device:
• For Red Hat Enterprise Linux 6
Execute the
udevadm
name) was not used in step 3 and step 4,
udev
name) has been specified, replace
udev
name) when reading the steps below.
command to check the mounted file system.
:
:
name was specified in steps 3 and 4, execute
udev
command. Specify the block device name for
3. Creating an HDLM Environment
LABEL
that you checked
LABEL
LABEL
column.
Filename
resume=/
with the
setting.
/
.
-n
181