Step 3: Place Batteries In The Remote Control; Step 4: Plug In Andturn On The System; Step 5: Complete The System Setup; Step 6: Order Programming - Hitachi 61HDX98B User Manual

SETUP AND CONNECTIONS
STEP 3: PLACE BATTERIES IN THE REMOTE
CONTROL
Follow these steps whenever you need to install or change the batteries in your TV's
remote control.
1. Remove the cover from the battery compartment.
2. Insert batteries into the battery compartment, matching
the + and - end of each battery.
3. Replace the cover.
STEP 4: PLUG IN ANDTURN ON THE SYSTEM
Plug one end of the power cord into the back of the television as shown on right.
Plug the other end into a wail outlet. Be sure to insert the plugs completely.
To turn on the TV, press the POWER button on the remote control or the POWER
button on the front panel. It may take several seconds for the TV to turn on.
STEP 5: COMPLETE THE SYSTEM SETUP
[]
m
lrv
System setup appears when you turn on your TV for the first time. Follow the steps to
configure the basics of your system, such as setting up the time and day, searching
for available channels, and setting up speakers. To run it again, select Assistance
from the main menu, then select System Setup. For more details, see the section
"Getting Assistance" in this book.
STEP 6: ORDER PROGRAMMING
You should decide if you would like to receive DIRECTV®programming.* To receive
DIRECTV programming, your satellite dish antenna must be installed and pointed
correctly. You must also contact _our service provider.
Programming with DIRECTV:
Call 1-800-347-3288
*DIRECTV programming is provided in accordance with the terms and conditions of
the DIRECTV Customer Agreement, a copy of which is provided with your first
DIRECTV billing statement. DIRECTV is a trademark of DIRECTV, Inc., a unit of
Hughes Electronics Corp., and is used with permission.
When you order
programming, you need
to know your access
card number. To get the
number, select
Assistance from the
main menu and then
select System Test.
Wait for the system to
run all of its tests. The
access card number is
displayed at the end of
the system test.
Write the access card
number in the space
below for easy
reference:
21