Table of Contents
Advertisement
Installing the bracket (continued)
ve
6 For projection screen sizes of less than 70 inches (both 4:3 and 16:10 screens),
remove the four dish screws (P) in the arm (M) and change the location of the
adjusting block (Q) as shown in the figure.
Tightening torque: 0.98 N•m (10 kgf•cm)
7 Attach the LCD projector to which the bracket (B) has been attached to the
g
adjusting block (Q).
Tighten the four M4 x 8 round head screws (H).
ith
Tightening torque: 0.98 N•m (10 kgf•cm)
(Q)
(B)
(H)
on
■ Never use screws other than those designated.
Failure to heed this warning may cause the projector to fall or other hazard resulting in damage or injury.
8 Connect the cables to the projector.
G)
B)
(P)
Note: This procedure is not required for 70 inches and larger projection screen sizes
(both 4:3 and 16:10 screens).
(LCD projector front panel)
Connect as shown in the above fi gure.
HAS-K252
(Q)
(LCD projector rear panel)
(H)
WARNING
13
(P)
Note: The adjusting knobs
should face the direction
shown in the fi gure.
(Q)
(B)
Advertisement
Table of Contents
