Table of Contents
Advertisement
2 Remove the base bracket (O) from the arm assembly (A).
Before attaching the arm assembly to a wall, remove the screws to disassemble it as shown in the figure below.
Before disassembly, place the arm assembly on a mat or the protective plastic it was shipped in to prevent
damaging the floor or the bracket.
(L) M5 shoulder screws (3)
(L) (P)
(L)
(P)
Note:
The groove in the base bracket (O) is engaged with the tab at the rear of the arm (M). Move the base bracket
away from the arm and then downward to remove it.
(M) Arm
* Part names in the figures on the following pages are indicated by the symbols given in the ( ) brackets.
HAS-K252
(P)
(L)
(M) Arm
Tab
(O) Base bracket
6
(O) Base bracket
(N)
M5 screw with spring
washer and flat washer
Tab (rear of arm)
3
■ U
■ U
■ U
e
■ If
■
■
Advertisement
Table of Contents
