Table of Contents
Advertisement
!-2. Attach the front cap (C) at the front end of the arm (M).
Engage the left, right and center claws.
The adjusting knobs can be removed.
Place them on the projections inside the front cap (C) for storage.
!-3. Attach the adjust cover (F) on the adjusting block.
As shown in the figure, engage the right claw with the opening in the adjusting block.
!-4. Attach the eight screw caps (D) on the screws on the arm (M).
Four locations on the right and left side
Press in the caps until they are properly seated.
out
HAS-K252
(C)
Adjusting knobs
19
Advertisement
Table of Contents
