Emergency Calls - Kenwood NEXEDGE NX-200 Instruction Manual

If your transceiver has been programmed with the Emergency
function, you can make emergency calls.
Note: Only the Auxiliary (orange) key and the optional speaker/
microphone PF (orange) key can be programmed with the
Emergency function.
1 Press and hold the key programmed as Emergency.
• Depending on the delay time programmed into your
transceiver, the length of time it takes to switch to Emergency
mode will vary.
• When the transceiver enters Emergency mode, the transceiver
will change to the Emergency channel and begin transmitting
based on how the transceiver is set up by your dealer. Transmit
periods are also set by your dealer.
2 To exit Emergency mode, press and hold the Emergency
key again.
• If the Emergency mode completes a preset number of cycles,
Emergency mode will automatically end and the transceiver
will return to the zone and channel that was in use before
Emergency mode was entered.
Note:
◆ Your dealer can set the transceiver to emit a tone when
transmitting in Emergency mode.
◆ Your dealer can set the transceiver to emit tones and received
signals as normal or mute the speaker during Emergency
operation.

EMERGENCY CALLS

37