Table of Contents
Advertisement
Messages
Table 12-1
Overview of messages, with event type and brief description
Default processor loaded
Warning
The default processor was loaded during the start.
Input 1: DCF77 OK
Information
After a disturbance, the correct DCF reception has been detected again.
Input 1: DCF77 signal disturbed
Information
During stable reception, a disturbance was detected in the DCF77 signal.
Input 1: GPS OK
Information
After a disturbance, the correct GPS reception has been detected again.
Input 1: GPS signal disturbed
Information
During stable reception, a disturbance was detected in the GPS signal.
Input 1: Signal timeout
Application
With monitoring activated, no signal was received within the parameterized timeout.
(alarm)
Check the status display, see Radio clocks via terminals (Chapter 9.1.1). If "no
signal" is shown in the status, check the wiring.
Input 1: Telegram OK
Information
A serial format has been detected (for the first time since failure).
Input 1: Telegram cannot be decoded
Information
The serial format cannot be decoded.
Firmware has been updated
System and
A firmware update has been performed, and the firmware has been updated.
Information
Firmware has NOT been updated
System and
A firmware update has been performed, and the firmware could not be updated.
Information
Flash file system has been formatted
System
The file system has been formatted.
Protected synchronization
Application
The protected synchronization was activated, a discontinuity was detected during the
external synchronization.
(alarm)
The message indicates an external synchronization error. See also Synchronization
(Chapter 9.3.2).
Internal error, please contact Support.
System
The message text specifies the exact error, and this is important, e.g. for Support
(Hotline).
Processor has been updated
System and
A processor update has been performed, and the processor has been updated.
Information
12-9
Siemens AG 2010 All Rights Reserved
®
SICLOCK
TC100 Operating Instructions
Advertisement
Table of Contents
