Messages - Siemens SICLOCK TC 400 Operating Instructions Manual

Messages

The messages are divided into four different event types:
• System (capacity for approx. 1500 entries)
• Application (capacity for approx. 4500 entries)
• Information (capacity for approx. 21500 entries)
• Warning (capacity for approx. 3000 entries)
Messages for which a going event is also triggered, are called persistent mes-
sages. Persistent messages are, for example, alarms.
Note
Each event type is managed in the device in a separate buffer. When a buffer is
full, the next message of this type overwrites the oldest message in the buffer.
The buffer for information is sufficient for approx. 45 days of operation. This is an
average empirical value. Depending on the operating conditions and plant config-
uration, the number of messages can differ from this value.
For further information, see also Archive (Section 7.4).
Table 12-1 Message overview with event type and brief description
Recording of an input synchronization
Information The recording of an input synchronization is pending as the threshold value has been
exceeded.
Battery has been disconnected
Application A user has disconnected the battery for storage via the configuration tool.
See also Battery (Section 9.3.6).
Battery has been connected automatically
Application The battery has been connected automatically after a minimum period of operation
See also Battery (Section 9.3.6).
Bootloader has been updated
System and The bootloader has been successfully installed.
information
Bootloader has NOT been updated
System and The bootloader could not be installed.
information
© Siemens AG 2007 All Rights Reserved
®
SICLOCK TC 400
12
12-101