Editing Parameters - Siemens SICLOCK TC 400 Operating Instructions Manual

Configuration Tool
7.3.3

Editing parameters

Requirement for the editing of a parameter entry
• It must be a writeable entry (
To change the value of a parameter entry:
1. Show the values of the desired parameter in the parameter table, see Show-
ing/hiding parameter table entries (Section 7.3.2).
2. Click the "Value" column of the parameter entry.
−> The dialog box to edit the entry is opened.
The input can be aborted with ESC.
Figure 7-5 Example of edit dialog box drop-down list
For parameters with units, you can also enter the new value without unit. Any
units that are entered are ignored, only the numeric value is accepted.
Figure 7-6 Example of edit dialog box numeric entry
Note
In online mode, the value is sent to the device when the input is completed.
To check whether the value has been accepted by the device:
1. In online mode, select the entry of the changed parameter, as described
above.
−> The current value in the device is displayed.
Note
Depending on the parameter/entry and operation status, the device checks
whether the value change has been accepted. If the device rejects the new value,
the old value is reset.
7-58
).
© Siemens AG 2007 All Rights Reserved
®
SICLOCK TC 400