Panasonic KX-T7400 Series User Manual Addendum page 17

<Example> To enter "Mike",
– Using the SELECT button (With a KX-T7431/KX-T7433/KX-T7436/KX-T7235)
See Combination Table 1.
1. Press 6 and then press the SELECT button once to enter "M".
2. Press 4 and then press the SELECT button six times to enter "i".
3. Press 5 and then press the SELECT button four times to enter "k".
4. Press 3 and then press the SELECT button four times to enter "e".
– Using the SHIFT button and a Soft button (With a KX-T7433/KX-T7436/KX-T7235)
See Combination Table 1.
1. Press 6 and then press the S1 button to enter "M".
2. Press 4 and then press the SHIFT and S3 button to enter "i".
3. Press 5 and then press the SHIFT and S2 button to enter "k".
4. Press 3 and then press the SHIFT and S2 button to enter "e".
– Using the Jog Dial (With a KX-T7431/KX-T7433/KX-T7436/KX-T7420/KX-T7425)
See Combination Table 2.
1. Press 6 and then rotate the Jog Dial one click to enter "M".
2. Press 4 and then rotate the Jog Dial six clicks to enter "i".
3. Press 5 and then rotate the Jog Dial four clicks to enter "k".
4. Press 3 and then rotate the Jog Dial four clicks to enter "e".
OR
1. Press 2 and then rotate the Jog Dial until "M" appears.
2. Press 2 and then rotate the Jog Dial until "i" appears.
3. Press 2 and then rotate the Jog Dial until "k" appears.
4. Press 2 and then rotate the Jog Dial until "e" appears.
Notes
• Pressing the SHIFT button alternates between capital and lower case letters. Once this
button is pressed, the SHIFT mode remains until SHIFT is pressed again.
• To erase the last letter (to backspace), press the CONF (Conference) button.
(The CONF (Conference) button becomes the " " (backspace) key when using the
overlay).
• To erase all the data, press the CLR (S2) button.
• If you keep rotating the Jog Dial, all of the characters will be displayed in order.
<Example> If you rotate the Jog Dial after pressing 2, all the characters will appear in the
A a B b .... Z z 0 (space) ! ? . , ' : ; * / + – = < > # $ # $ % & @ ( ) A a ....
Conditions
• The default is "Not Stored".
• Up to ten dialling numbers and names can be assigned. Each dialling number has a
maximum of sixteen digits and each name has a maximum of ten characters.
Station Programming
following order:
17