Table of Contents
Advertisement
Parts and their functions
Rear panel
VIDEO IN
VIDEO OUT
GEN-LOCK
Y/VIDEO
MONITOR
P R
P B
RET
COMMUNICATION
INCOM IN
PUSH
CAMERA
INCOM OUT
GEN LOCK connectors
The reference signals for synchronizing the whole
system are supplied to these connectors.
RET connectors
The return signals which are transmitted to the
camera recorder are supplied to these connectors.
CAMERA connector
This connector is connected to the camera adapter
(AJ-CA905G) using the 26-pin cable and used for
communication and transmission.
Y, P
, P
connectors
B
R
The analog component signals are output from
these connectors.
<Note>
When the AJ-SDC905 is used as the camera
recorder, video signals can be output to the Y
connector by means of a menu setting.
MONITOR connector
The video signals for monitoring purposes are
output from this connector.
TALLY connector
This is the input/output connector for the red tally
signal and green tally signal. It can be used for the
picture monitor tally signal, etc.
COMMUNICATION connectors
(INCOM IN, INCOM OUT, PGM IN)
These connectors are used to connect the INCOM
(Inter-Communication) system.
10
(VJH1247)
TALLY
PGM IN
PUSH
AC IN
FUSE
T2.5AH 250V
AUDIO OUT
SIGNAL
GND
AUDIO OUT connector
The audio signals of the camera recorder are
output from this connector.
FUSE
This is the fuse for the unit's main power supply.
Use a dedicated fuse (250 V, 2.5 A) which is
designed to withstand inrush currents.
SIGNAL GND terminal
This is the grounding terminal.
AC IN socket
This is connected to the power outlet using the
power cord supplied with the unit.
Advertisement
Table of Contents
