Panasonic AJ-RC905P Operating Instructions Manual page 6

Remote control unit
Hide thumbs Also See for AJ-RC905P:
Table of Contents

Advertisement

Parts and their functions
Front panel
ENABLE
MONITOR
CHROMA
CABLE LENGTH
100m
50m
Y/VIDEO
CHROMA
(PUSH)
PR
INTERCOM
MIC
ON
OFF
PB
RCU
CAMERA
KNEE POINT
PGM
PUSH
POWER
KNEE SLOPE
OFF
ON
BBS
XLR connector for INCOM
Connect the headset used for INCOM (Inter-
Communication) here.
PGM dial
This is used to adjust the audio level of the program
being recorded which is multiplexed with the output
signals of the headset used for INCOM.
RCU:
For INCOM connected to the unit.
CAMERA:
For INCOM connected to the camera adapter.
INTERCOM dial
This is used to adjust the volume of the INCOM
sounds received.
MIC switch
This is the ON/OFF switch of the microphone for
INCOM.
CABLE LENGTH selector switch
This is set to the distance that corresponds to the
length of the 26-pin cable.
100m:
When using the 100-meter cable (AJ-C26100G)
50m:
When using the 50-meter cable (AJ-C26050G)
6
VTR
REW
FF
STOP PLAY
REC CHK
START/STOP
CALL
ON
TALLY
OFF
VTR WARNING
SET UP
SHUTTER
GAIN
AWB
BAR
WHITE
BAL
ABB
AUTO KNEE
A
B
POS2
POS3
PRST
POS1
POS4
SV
POS5
PAINTING
SS
POS6
GAIN
DETAIL
ENABLE
R
B
BLACK
GAMMA
AUTO IRIS
IRIS
GAIN FILTER
M.PED
CHECK
VTR ENABLE switch
This is set to ON when using the unit to operate the
VTR part of the camera recorder.
ON:
The VTR part of the camera recorder is operated
using the unit's front panel controls (
OFF:
The ability to operate the VTR part of the camera
recorder using the unit's controls is disabled.
REW button
This is the REW button of the VTR part.
FF button
This is the FF button of the VTR part.
STOP button
This is the STOP button of the VTR part.
PLAY button
This is the PLAY button of the VTR part.
<Note>
The images seen when the VTR part is played are
output from the MONITOR connector, but the
playback signals are not output from the Y, P
and AUDIO OUT connectors.
REC CHK button
This button indicates the recording status of the
VTR part.
START/STOP button
This button starts or stops the recording operation
of the VTR part.
VTR WARNING lamp
This indicates that an operating error has occurred
in the VTR part.
For details on errors, refer to the operating
instructions accompanying the camera recorder.
to
).
, P
R
B

Advertisement

Table of Contents
loading

Table of Contents