Setup As Smtp Mail Server - Panasonic DP-2000 Operating Instructions Manual

Pre Installation Information

Setup as SMTP mail server

To install the DP-2000 as SMTP mail server, the following network parameters need to be programmed on your
network and on the DP-2000.
• IP Address of the DNS Server (if not available, see Note)
• IP Address of the DP-2000
• Subnet Mask of the DP-2000
• Name or IP Address of the Default SMTP mail server
• IP Address of the Default Router
• Email Address of the DP-2000 (see Note)
• Host Name
Email Transmission (from the DP-2000 to a PC)
ifaxuser@fax01.panasonic.com
popuser001@panasonic.com
Email reception (from a PC to the DP-2000)
ifaxuser@fax01.panasonic.com
popuser001@panasonic.com
NOTE
1. To function as SMTP mail server, the DP-2000's email address must include its unique Host name within your
company domain. This unique Host name must be registered within your network's DNS (Domain Name System)
server. Example: DP-2000@fax01.panasonic.com
2. By default the machine requires the IP Address of the DNS Server and prompts you to enter the SMTP Server
Name. If the DNS Server is not available, change the Fax Parameter No. 161 (DNS SERVER) to "1:Invalid".
Then the machine will prompt you to enter the IP Address of the SMTP Server.
3. Dynamic Host Configuration Protocol (DHCP) is not supported.
GETTING TO KNOW YOUR MACHINE
(see Note 1) (see Note 2) (see Note 3)
(Router)
SMTP
POP3
(Router)
SMTP
SMTP01.panasonic.com
(SMTP Mail Server)
POP02.panasonic.com
(POP Server)
SMTP01.panasonic.com
(SMTP Mail Server)
13