Toshiba E6580772 Instruction Manual page 15

Continuous operation depends on the status information that was before the communication error happens.
Display of communication error will be [t].
Display of trip will be [err8].
When interrupting a transmission to change the setting of command input, reboot a power supply if
necessary, since the data which have been received before the interruption of transmission are stored in
the inverter.
Parameter setting of smaller communication number will be valid in case that the same setting values are
allocated to the command input setting which are between 1 and 6, and also to the monitor output setting
between 1 and 6.
(Note 3) The setting of communication error detection time is relating to the number of stations connected
to the communication line. When changing the setting, fully consider the number of connected stations.
Other parameters
The following parameters reflect the transmitted data in the control of the inverter.
Parameter name
Operation
cmod
command mode
selection
Speed setting
fmod
mode selection
Torque command
f420
selection
Selection of
f422
synchronized
torque bias input
Selection of
f423
tension torque
bias input
Load sharing gain
f424
input selection
Power running
f440
torque limit 1
selection
Selection of
f442
regenerative
torque limit 1
Title Setting value
4
9
9
5
5
5
5
5
Validates the command sent from the F10M option.
Operation such as run/stop from the other station will be
possible.
Validates the speed reference value from the F10M option.
Validates the torque command value from the F10M option.
Validates the synchronized torque bias from the F10M
option.
Validates the tension torque bias from the F10M option.
Validates the load sharing gain from the F10M option.
Validates power running torque limit from the F10M option.
Validates regenerative torque limit from the F10M option.
14
E6580772
Details