Siemens C2-010 User Manual page 18

C2-010 / C2-010-I ADSL2+ Router User's Guide
3. Under the Static IP heading, choose the Connection Type from the pull-down menu. This defines both the
connection type and encapsulation method used for your ADSL service. The available options are Bridged
IP LLC, Bridged IP VC-MUX, Routed IP LLC, Routed IP VC-MUX or IPoA.. If have not been provided
specific information for the Connection Type setting, leave the default setting.
4. Change the IP Address, Subnet Mask, Gateway Address and (if available) Secondary DNS Server IP
address as instructed by your ISP. These are the global IP settings for the WAN interface. This is the
"visible" IP address of your account. Your ISP should have provided these IP settings to you. For IPoA
(Classic IP over ATM) connections you may need to type in an additional IP address for a ARP Server
Address. If you are using an IPoA connection, ask your ISP if it is necessary to use an ARP (Address
Resolution Protocol) server.
5. Leave the MTU value at the default setting (default = 1400) unless you have specific reasons to change
this (see table below).
6. Most users will not need to change ATM settings. If this is the first time you are setting up the ADSL
connection it is recommended that you leave the Service Category settings at the default values until you
have established the connection. See the table on page
parameters available for ATM traffic shaping.
7. When you are satisfied that all the WAN settings are configured correctly, click on the Apply button.
8. The new settings must be saved and the Router must be restarted for the settings to go into effect. To
Save & Reboot the Router, click on the Tools directory tab and then click the Save & Reboot menu
button. In the Save and Reboot menu, click the Reboot button under Force the DSL-300T to system
restart. The Router will save the new settings and restart. Upon restarting the Router will automatically
establish the WAN connection.
Additional settings for Static IP Address connections:
Static IP
Address
Parameters
Connection This specifies the connection type and the encapsulation method used for your Static IP
Type Address connection. The options available are Bridged IP LLC, Bridged IP VC-MUX, Routed
IP LLC, Routed IP VC-MUX or IPoA.
IP Address This is the permanent global IP address for your account. This is the address that is visible
outside your private network. Get this from your ISP.
Subnet This is the Subnet mask for the WAN interface. Get this from your ISP.
Mask
Gateway This is the IP address of your ISP's Gateway router. It provides the connection to the Router
Address for IP routed traffic that is outside your ISP's network. That is, this will be the primary
connection from the Router to most of the Internet. Get this IP address from your ISP.
Primary This is the IP address of the first choice for Domain Name Service (DNS) used to match the
DNS named URL web address used by most browsers with the actual global IP address used for
Address a web server. Usually this will be a server owned by the ISP. Get this IP address from your
ISP.
Secondary This is the second choice for a DNS server. Get this IP address from your ISP.
DNS
Address
Enabled/Disabled − this sets the router as the default route between the PCs on your LAN
Default
and the WAN (Internet). This should normally be enabled.
Route
. ‫הסימניה אינה מוגדרת‬
Description
4-6
! ‫שגיאה‬
for a description of the