NEC Express5800/320Fd-LR User Manual page 94

4-30 Windows Setup
1) When the dialog box for confirmation of executing system update appears, click [OK]. The
system update will start. Follow the instructions.
2) After the system update is completed, the dialog box below will be displayed. Click [OK].
The system will be rebooted. Eject a DVD from CD/DVD-ROM drive after the reboot
process starts.
IMPORTANT:
When "Found New Hardware" wizard appears at the
reboot, click [Cancel]. If the same message appears again, click [Cancel] again.
3) Reboot the system.
15. Install ft Server Control Software
IMPORTANT:
Terminate all programs before starting the installation.
You must terminate all programs because the software will not be installed successfully,
especially when Microsoft management console is running.
1. Follow the steps below to install ft Server Control Software.
a) After logging on to the system as a user with the Administrative account, insert the
"NEC EXPRESSBUILDER" DVD-ROM into the DVD-ROM drive of the server.
b) The menu screen starts up. Click [Setup software] and select [ft Server Control
Software] on the menu.
Follow the instructions to with the installation. The message "ft Server Control
Software, Now Installing... Please Wait." is displayed while ft Server Control Software.
Do not use the keyboard or mouse while this message is being displayed.
2. The system is rebooted during the installation.
The system is rebooted several times during the installation. Remove the DVD from the
DVD-ROM drive once rebooting is started.
After the system is rebooted, log in again as the user logged in before rebooting.
Installation of the ft Server Control Software is continued.
3. The message "Installation finished." is displayed.
Once the installation is completed, the message "Installation finished." is displayed and