Changing Drive Letters - NEC Express5800/320Fd-LR User Manual

the rebooting starts by clicking [OK]. Change this screen to check the message, as the
message can hide behind the screen.
For using "ft Server Control Software UPDATE CD-ROM" to update ft Server Control
Software:
After installing the ft Server Control Software, follow the procedure on the setup card
attached to the "ft Server Control Software UPDATE CD-ROM" and apply the update.
16. For how to install NEC ESMPRO/ServerAgent,
see "NEC ESMPRO Agent"(Page 5-3).
IMPORTANT:
Make sure that "System Update" is applied and that "ft Server Control Software" and "NEC
ESMPRO Agent" are installed.
Follow Step5.

Changing Drive Letters

You can change the drive letters with the following procedure:
NOTE:
The following procedure does not change the drive letters for the system volume or
the boot volume.
Go to the start menu, right click [My Computer], select [Manage] and then launch
1.
[Computer Management].
Select [Disk Management] in the left window.
2.
Select and right-click a volume that you want to change the drive letter,
3.
then select [Change Drive Letter and Path for...].
Click [Change].
4.
Click [Change Drive Letter or Path], then select a letter for the drive.
5.
Click [OK].
6.
Click [Yes] after confirming the following message.
7.
Changing the drive letter of a volume might cause programs to no longer run.
Are you sure you want to change this drive letter?
Exit [Computer Management].
8.
Windows Setup 4-31