Table of Contents
Advertisement
4.
Install the I/O connector cover.
Figure 46. Removing and Installing a CMC Module or iKVM Module (CMC Module Shown)
1. I/O connector cover
2. release latch
3. release lever
Installing An iKVM Module
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1.
Remove the I/O connector cover.
2.
Open the iKVM module handle.
3.
Slide the module into the enclosure until the handle contacts the enclosure.
4.
To fully seat the module, close the handle until the release latch snaps into place.
5.
If applicable, connect the keyboard, monitor, and mouse to the module.
I/O Modules
CAUTION: If you remove an I/O module, you must either replace it with another I/O module or with a filler blank to
maintain cooling airflow through the system enclosure.
84
Advertisement
Table of Contents
Troubleshooting
