Before Installation; About The Mounting Platform; Positioning The Projector Towards The Screen - Sony SRX-T105 Installation Manual

Before Installation

Necessary clearance for installation and
maintenance
For maintenance service and to prevent internal heat build-
up, be sure to provide enough room around the projector
when it is installed.
For details, see "Necessary Clearance for Installation and
Maintenance" (page 41)

About the Mounting Platform

This projector can be installed at an angle of ± 90 degrees.
To install at ± 90 degrees angle, attach a mounting
platform that can return to the normal angle as shown in
the figure below to this projector.
The mounting platform is not available as an optional
accessory. Prepare the mounting platform shown in
"Mounting Platform Dimensions" (page 39).
Mounting platform
Note
Attach the optional LKRA-001 exhaust duct adaptor when
installing at ± 90 degrees angle. When attaching the
adaptor, be sure to provide enough room for smooth
exhaust flow and take care not to bend the duct.
Positioning the Projector towards
the Screen
Install the projector so that the center of the lens is between
the bottom edge and the top edge of the screen. You can
move the picture position vertically by half of the screen
vertical size using the lens shift adjustment.
Leave some
space
Vertical positioning (side view)
Center of lens
Screen
Horizontal positioning (top view)
Screen
Adjustable range with lens
shift feature
Center of lens
Before Installation
11