Fujitsu fi-4340C Operator's Manual page 69

1 Setting double feed detection (Paper Thickness)
When you set the use of double feed detection, you must set it as follows:
1. Press or
Screen 1
2. At Screen 1.
Press either the or
(transmitted light).
The paper thickness is checked using the difference between two consecutive sheets of paper fed
from the ADF. On this screen, select whether or not to check for double feeding, and select the error
processing.
Each time either of these buttons is pressed, the location of the blinking moves. When the
pressed, the blinking moves from (1) to (3). When the
opposite direction. However, if the setting by the host computer is valid, the location of the blinking
does not move when either button is pressed.
(1) "No" is blinking: Paper thickness is not checked.
(2) "Yes" and "1" are blinking: Paper thickness is checked. However, a detected double feed error
is displayed on the screen only; processing is continued.
(3) "Yes" and "2: Stop" are blinking: Paper thickness is checked. When the double feed error is
detected, the scan processing is stopped. The error is then reported to the host.
If you want to disable the double feed, select "No" then press
NOTICES
1. Double Feed detection might have better results when both the paper thickness and the paper length
are used.
2. When the document in ADF is not the double fed document, the previous document might be double
fed, in case the scanner stops feeding by using the double feed detection.
3. Depending on the type of printing on the document, a double feed may not be detected by the paper
thickness.
and let the scanner display Screen 1.
button to set the double feed detection according to the paper thickness
button is pressed, the blinking moves in the
. Press to return.
button is
G 7-5