Fujitsu fi-4340C Operator's Manual page 70

2 Setting double feed detection (Paper Length)
1. Press or
Screen 2
2. Press either the or
length is checked using the difference between two consecutive sheets of paper fed from the ADF.
Each time either of these buttons is pressed, the location of the blinking moves. When the
pressed, the blinking moves from (1) to (3). When the
opposite direction. However, if the setting by the host computer is valid, the location of the blinking
does not move when either button is pressed.
(1) "No" is blinking: Paper length is not checked.
(2) "Yes" and "1" are blinking: Paper length is checked. However, a detected double feed error is
displayed only on the screen; processing is continued.
(3) "Yes" and "2: Stop" are blinking: Paper length is checked. When the double feed error is
detected, the scan processing is stopped. The error is then reported to the host.
If you want to disable the double feed, select "No" then press
After pressing
Screen 3
3. Press either the or
pressed, the blinking moves from (1) to (3). When the
opposite direction.
(1) The "10" is blinking: Threshold is 10mm
(2) The "15" is blinking: Threshold is 15mm
(3) The "20" is blinking: Threshold is 20mm
G 7-6
and let the scanner display Screen 2.
button to set double feed detection according to paper length. The paper
, the scanner displays the Screen 3.
button to set double feed detection (paper length). When the
button is pressed, the blinking moves in the
. Press to return.
button is pressed, the blinking moves in the
button is
button is