Back to Contents Page
Display
Dell™ Vostro™ 1510
Service Manual
Display Assembly
Display Bezel
Display Inverter
Display Panel
Display Cable
Camera and Microphone Assembly
Display Assembly
Removing the Display Assembly
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Follow the instructions in
Before Working on Your
2. Remove the hard drive cover. See
3. Remove the WLAN card (see
4. Remove the M2.5 x 8-mm screw that attaches the display assembly to one corner of the computer.
5. Remove the hinge cover (see
6. Remove the keyboard (see
7. In sequential order, remove the four numbered M2.5 x 5-mm screws from the base of the display assembly.
8. Disconnect the display cable from the display cable connector on the system board.
9. Lift the display cable and antenna cables from beneath the tabs on the palm rest.
NOTICE:
Ensure that the display cable and the antenna cables do not get caught beneath the plastic tabs on the palm rest.
10. Gently tug on the antenna cables to remove them from underneath the palm rest.
NOTE:
The antenna cables are no longer attached to the WLAN card which you removed in
unattached, they can be difficult to remove from underneath the palm rest. You may want to turn the computer upside down and remove the hard drive
compartment cover and memory cover in order to have better access to the antenna cables.
Computer.
Removing the Hard Drive
for an illustration of the hard drive cover.
Removing a WLAN
Card).
Removing the Hinge
Cover).
Removing the
Keyboard).
step 3
of this procedure. Although the cables are