Back to Contents Page
Palm Rest
Dell™ Vostro™ 1700 and Inspiron™ 1720/1721 Service Manual
Removing the Palm Rest
Replacing the Palm Rest
Removing the Palm Rest
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
1. Follow the instructions in
Before You
2. Remove the optical drive (see
3. Remove the hard drive (see
4. Remove the hinge cover (see
5. Remove the keyboard (see
6. Remove the display assembly (see
7. Remove the internal card with Bluetooth wireless technology, if installed (see
NOTE:
It is not necessary to remove the Bluetooth cable connector from the system board connector.
8. Remove the sixteen M2.5 x 8-mm screws from the bottom of the computer.
NOTE:
The screw locations may vary slightly from the image shown below.
9. Turn the computer over and remove the six M2.0 x 3-mm screws that secure the top of the palm rest.
10. Disconnect the touch pad connector from the system board.
Begin.
Removing the Optical
Drive).
Removing a Hard
Drive).
Removing the Hinge
Cover).
Removing the
Keyboard).
Removing the Display
Assembly).
Removing the Bluetooth
Card).