Kenmore 721.33189 Owner's Manual page 15

WARNING
Electric Shock or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in
electric shock or personal injury
=rom cleaner suddenly starting.
Frequently check and remove hair, string and
lint build-up in the brush area. If build-up
becomes excessive, follow the steps below.
TO REMOVE BELT
Disconnect power cord from electrical outlet.
Place the
carpet/bare floor
selector in the
carpet position and
lower handle to lay
vacuum body flat.
Carpet/Bare
Floor Selector
to Carpet Position
Latches
Slide E-Z Belt
Check latches
outward and
remove nozzle
cover. Nozzle /
Cover
Position hands on the agitator. If the belt is still
attached to the agitator, sever with scissors and
remove it. Carefully lift the right end of the
agitator and then the left end.
Agitator_
/
Belt
Note: It may be necessary to pull on the edge
of bumper to allow the ends of the agitator to
be removed easily.
TO CLEAN AGITATOR
Note: In order to keep cleaning efficiency high
and to prevent damage to your vacuum, the
agitator must be cleaned every time the belt is
changed.
The agitator must be cleaned according to the
following schedule:
Vacuum Use Clean Agitator
HEAVY every week
(used daily)
MODERATE every month
(used 2-3 times/week)
LIGHT
(used 1 time/week)
every2 months
Carefully remove the brush end caps and
remove any string or debris located on the
agitator assembly, end caps or agitator shaft.
Replace the end caps. See AGITATOR
ASSEMBLY.
-15-