On/Off Switch; Attachments - Kenmore 721.33189 Owner's Manual

Release the handle by pressing down on the
handle release pedal with your foot and pulling
back and down on the handle with your hand.
b
Handle
Release Pedal
The On/Off switch is located on the vacuum
The vacuum
cleaner has
three positions:
- Uprightfor storage
andwhenusing
cleaningtools.
- Angledforcarpet
andfloor
cleaning.
- Lowfor reaching
underfurniture.
cleaner body just below and to the side of the
handle. Push the switch to ON to start the
cleaner, and to OFF to stop it.
Pc°off ,
- Handle
L.___ On/Off
Switch
Wand
Dustinc 1
Brush
Stretch
Hose
Hose Connector
TO USE ATTACHMENTS
Place the bare floor selector in the bare
floor setting by pushing the selector back
and down to the bare floor setting. See
CARPET/BARE FLOOR SELECTOR.
Remove the lower end of the stretch hose from
the cleaner by grasping the hose connector,
twisting and pulling straight out.
NOTE: The motor protector may open causing
poor pick up, when using attachments or when
cleaning new carpet, due to reduced airflow
caused by the attachments themselves, or by
new carpet fuzz filling the bag quickly. See
CLOG REMOVAL.
WARNING
Electric shock and Personal Injury
Hazard
Disconnect electrical supply before servicing
or cleaning the unit. Failure to do so could
result in electric shock or personal injury from
cleaner suddenly starting.
-8-