Before Calling; For Service - LG LRE30451SW Owner's Manual & Cooking Manual

BEFORE CALLING FOR SERVICE
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not
the result of defective workmanship or materials in this appliance.
Possible cause / Solution
• Poor installati on. Place oven rack in center of oven. Plaee a level on the oven rack.
•
Adjust leveling legs at
base
of range until the
oven
rack is level.
• Be sure
floor is level and is strong and stable
enough to adequately
support range.
•
If floor is sagging
or
sloping, contact
a
carpenter to correct the situation.
Kitchen cabinet
alignment may make range appear unlevel. Be
sure cabinets are
square
•
and have sufficient
room
fur range clearance.
NNNot vN N_iINN N
Cabinets not square
or are
built in
too tightly.
Contact builder
or
installer to make
appliance
• accessible.
Carpet interferes with range. Provide sufficient spaee so range can be lifted over carpet.
d]_:_:: condition Press CLEAR/OFF to clear
................................................................................................................... ....... F-1 Shorted keypad
me alspmy aria stop Deepmg. "F-2 .......E)ooi ockng sysiem clon;iopeiaie .......................
Reprogram oven. If fault recurs record .................................................................................................................
- F-3
Open oven sensor
fault number. Press CLEAR/OFF and .................................................................................................................
contact a Service agent ..... ..S.h?rt?d..°}(.ePseD._c_r . ...................................................
F-7 No heating
F-9 Oven is too hot
• Improper cookware being used.
- Use pans which are flat and match the diameter of the surface unit selected.
• In some areas, the power (voltage) may be low.
- Cover pan with a lid until desired heat is obtained.
• A fuse in your home may be blown or the circuit breaker tripped.
- Replace the fuse or reset the circuit breaker.
• Cooktop controls improperly set.
- Che& to see the correct control is set for the surface unit you are using.
• This is normal. The unit is still on and hot.
• Food spillovers not cleaned befure next use.
- See Cleaning the glass cooktop section.
• Hot surface on a model with a light-colored cooktop.
- This is normal. The surface may appear discolored when it is hot. This is temporary and
will disappear as the glass cools.
• This is normal.
- The element will cycle on and off to maintain the heat setting.
3O