Installing The Ups - NEC Express 5800 User Manual

3. Slide the interface expander all the way into the slot, until the end plate is
flush with the back panel of the UPS.
4. Secure the accessory with the two screws removed in Step 1.
5. If the installation does not include PowerChute
following topics with the System Administrator:
Configuration switch settings (Figure 5-4, A); see Section 7 of the UPS
!
Interface Expander Accessory document, and
Status Light; see Section 10 of the UPS Interface Expander Accessory
!
document.
Note: When installed and configured, PowerChute
software overrides UPS configuration switch settings.

Installing the UPS

To install the UPS:
1. Install the four M6 cage-nuts that will secure the front of the UPS to the
rack. Position the cage-nuts to align with the screw holes in the front bezel
of the UPS. Use the template provided with the UPS.
2. As illustrated in Figure 5-6, assemble the L-channel support brackets (A)
and adjust the rails to span the depth of the rack.
Figure 5-5. Installing M6 Cage-Nuts
®
plus software, review the
®
plus
A
Installing Rack Components 5-7