Configuring The Parallel Ups Card - HP R1500 - UPS XR User Manual

Remove the two screws securing the X-Slot Card and slide the card out.
3.
To replace the component, reverse the removal procedure.
NOTE:
restarted or reconfigured.

Configuring the Parallel UPS Card

Unpack the Parallel UPS Card, and be sure that the card was not damaged during shipment.
1.
NOTE:
Communication Bay 2.
Remove the UPS X-Slot communication bay cover, and retain the screws.
2.
Set the jumper pins on the Parallel UPS Card according to the parallel configuration.
3.
For three or more paralleled UPSs:
Set the cards of the first and last UPS to Pins 1 and 2.
o
Replacing the HP Management Module might require power management software to be
If installing another X-Slot card, be sure to install the Parallel UPS Card in X-Slot
Maintenance 84