Husqvarna 36 Workshop Manual page 55

Assembly
Saws 36, 40, 41, 45, 42,
242XP, 246, 51, 55,
254XP, 257 and 262XP.
Saws 36, 41, 42, 242XP,
246, 51, 55, 254XP, 257,
262XP and 394.
On saw 394, fit the cable
to the trigger. Insert them
into the handle from the
front.
Fit the pin (B) and spring
(when used).
B
SAFETY EQUIPMENT
Other saws.
Fit springs in appropriate cases.
Saws 61, 268, 268K,
272XP, 272K, 272S,
281XP and 288XP.
See next page.
Fit the cable to the trigger
and install the throttle lock
and trigger.
Fit the side of the handle
using three screws on the
side and one underneath,
which holds the spring.
All saws except 40 and 45 continue on the next page.
!
WARNING!
The fuel used in the chain saw
poses the following hazards:
1. The liquid and its vapours
are poisonous.
2. Can cause skin irritation.
3. Is highly inflammable.
Saws 40, 45.
Fit the trigger with the cable
from the front.
Fit the spring and slide the
throttle lock forwards from
above so that its rear edge
can be slid in under the edge
of the handle.
Saw 3120.
55
English –