Husqvarna 36 Workshop Manual page 79

Saw 3120.
Fit the oil pump as follows:
1. Apply SAE 30 oil to all moving parts
2. Fit the seal (C).
3. Fit the pump piston (D) with spring.
Press in the piston and hold it in
position with a screwdriver from the
pump housing's inside in slot (E).
4. Fit screw (B) so that it is positioned
approx. one turn from the bottom.
NOTE! Left-hand thread
Fit the wire for manual oil supply.
LUBRICATION SYSTEM
5. Fit lever arm (F).
6. Fit units (B-F-G) with spring (H) and
screw in position using screws (A) and
latch (J).
7. Remove the screwdriver.
8. Fit a new O-rings (K) and (L).
F D
C K
See continuation on next page.
E
H
G
J
B A
79
English –