Stopping Background Initialization; Performing A Manual Rebuild Of An Individual Physical Disk - Dell 6 series User Manual

Restrictions and Limitations
The following restrictions and limitations apply to the Replace Member
operation:
• The Replace Member functions are restricted to one per array for RAID 0,
RAID 1, and RAID 5, and two per array for RAID 6.
• The Replace Member function and rebuild function cannot run
simultaneously on a RAID 6 virtual disk. The rebuild operation has a
higher priority, and the Replace Member operation is aborted if a rebuild
begins.

Stopping Background Initialization

Background Initialization (BGI) is the automated operation in which parity is
created and written. BGI does not run on RAID 0 virtual disks. Under certain
conditions, the BIOS Configuration Utility displays a message if you want to
stop BGI in progress. An alert message displays if BGI is in progress and you
start any of the following actions:
• A Full Initialization on the virtual disk
• A fast initialization on the virtual disk
• A consistency check on the virtual disk
The following alert message displays: The virtual disk is
undergoing a background initialization process. Would
you like to stop the operation and proceed with the
<full initialization/quick initialization/consistency
check> instead?
Click Yes to stop the BGI and start the requested operation or No to allow
BGI to continue.

Performing a Manual Rebuild of an Individual Physical Disk

Use the following procedures to rebuild one failed physical disk manually.
1 Press <Ctrl><N> to access the PD Mgmt screen.
A list of physical disks displays. The status of each disk displays under the
heading State.
2 Press the down-arrow key to highlight a physical disk that has a failed state.
108
Configuring and Managing RAID