Electrical Connection; Temperature Setting - Electrolux CS 110 Installation & Operating Instructions Manual

Electrolux wine racks & cellars
Hide thumbs Also See for CS 110:
Table of Contents

Advertisement

1.
Remove the transport pallet on which your
wine cellar rests.
2.
Adjust the feet to allow a 30 mm clear-
ance under the wine cellar and verify
that it stands in a vertical position in both
directions. If necessary, use a spirit level.
3.
For optimum performance, please place
your wine cellar far away from any source
of heat, e.g. radiator, cooker or intense
sunlight.
.
Check that the charcoal filter is in place at
the top left corner inside the wine cellar.
5.
Fit the door handle to the door, see "Ap-
pendix A".
6.
Attach the drip tray on the back. The
screws are already attached at the back.

electrIcal connectIon

The electrical installation must be carried out cor-
rectly, taking into account all relevant regulations
and codes of practice. The wine cellar operates on
a single-phased alternating current.
Please check that the voltage shown on the data
plate corresponds to your power supply.
!
the wine cellar must be earthed.
The wine cellar is fitted with a plug intended for an
earthed socket. Electrolux and its subsidiaries will
not be held responsible for any incident due to non-
existent or defective earth wires.
Electrical leads must be routed and secured so
that they cannot come into contact with hot or
sharp parts of the wine cellar.

temperature settIng

Plug in the wine cellar and turn it on with the ON/
OFF switch.
The wine cellar is equipped with an electronic con-
trol. This allows you to programme the temperature
inside the wine cellar. The wine will be stored be-
tween 10°C and 15°C according to expert advice.
and 15°C according to expert advice. The tem-
perature, pre-set at 12°C in the factory, is shown
on the display. The temperature can be changed on
demand between 8°C and 18°C depending on the
wine stored.
1.
Press and hold the UP
arrow button for a few seconds until the
display starts blinking.
2.
Release the button. Press the UP/DOWN
arrow buttons to set the temperature.
The new value is saved automatically
after 6 seconds.
-  -
WARNING
or DOWN
(
)
(
)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cs 160Cs 200

Table of Contents