NEC Express5800 Series User Manual page 10

Esmpro agent
Hide thumbs Also See for Express5800 Series:
Table of Contents

Advertisement

6 Installation of the NEC ESMPRO Agent
If TCP/IP and SNMP Service are installed, go to the next section, "Installation of the NEC
ESMPRO Agent Software".
If they are not installed, continue as follows.
Installation of TCP/IP Protocol
a)
Press the "Start" button, highlight "Settings", and select "Control Panel".
b)
Double click on the "Network Connections" icon.
c)
Double click on the "Local Area Connection".
d)
Click on the "Properties".
e)
Click on the "Install".
f)
From the "Select Network Component Type" dialog box chose "Protocol" and press
"Add...".
g)
From the "Select Network Protocol" dialog box chose "Internet Protocol [TCP/IP]"
and press "OK".
h)
Highlight "Internet Protocol [TCP/IP]" in the "This connection uses the following
items:" and click on "Properties". Set the following TCP/IP configuration parameters
in "General" tab:
– IP address
– Subnet mask
– Default gateway, if needed
NOTE:
Address page since the NEC ESMPRO Manager already contains the
Agent's IP address.
Be careful that IP addresses and host names in the same network do not
overlap.
Installation of SNMP Service
a)
Press the "Start" button, highlight "Settings", and select "Control Panel".
b)
Double click on the "Add or Remove Programs" icon.
c)
Click on the "Add/Remove Windows Components" button.
d)
From the "Windows Components Wizard", chose the "Management and Monitoring
Tools" and click the "Details..." button.
e)
Check the "Simple Network Management Protocol" check box, and click the "OK"
button.
f)
Click "Next" button.
Do not check "Obtain an IP address automatically" on the IP

Advertisement

Table of Contents
loading

Table of Contents